How to Install Plantation Shutters

Hidden Frame (Recess Fit):

For a hidden frame, mark 30mm in from the front of the window frame in 3 places on the height and width.

Line up the hang strip with the hinge facing forward along the 30mm line. Take the time to make sure this part is precise – it will make the rest of the installation much easier.

Screw them into place. You should use at least one screw per hinge.

Take the light block piece and line up along the 30mm marks and also screw into place – typically one on each end and another in the middle is usually sufficient.

Framed Shutter:

For a framed shutter, the frames are marked top bottom left and right.

Place the frame face down on a soft surface like carpet, a rug or towel as to not damage the face of the frame.

Join the frame together, tap really gently with a hammer if required.

Recess Fit Framed Shutter:

For a recess fit, using a straight edge as a guide, line the shutter frame to the front of the window.

Screw in the four corners of the frame.

Now place another screw for every hinge.

Screw the top and bottom at least on the four corners and centre.

Face Fit Framed Shutter:

Note: Face fit frames are typically made the same size as your architrave. For larger frames such as this one, please call 0477011346 for advice.

For a face fit, line the top of the frame, with the top of the architrave. Screw in the centre top and then the two corners.

Repeat with the bottom and sides.

Adjustments:

If the shutter panel is touching the top or bottom of the window frame, you can adjust the shutter by slightly loosening the hinge screws and raising or lowering the panel.

Once adjusted, insert the locking screw. Remove the double sided tape and insert the cover strip.

For a face fit, it looks something like this.